https://www.cutoutandkeep.net/projects/not-so-itty-bitty-bows • Posted by Andi
Nothing makes a statement like a big bow! This project is great for an adventurous beginner, and it's incredibly quick to make. Materials: 3.75mm Knitting Needles DK or Worsted Weight Yarn Scraps Coordinating Thread A needle narrow enough to fit through the slits on top of the clip Conair Hair Clips for Roller Set
Nothing makes a statement like a big bow! This project is great for an adventurous beginner, and it's incredibly quick to make. Materials: 3.75mm Knitting Needles DK or Worsted Weight Yarn Scraps Coordinating Thread A needle narrow enough to fit through the slits on top of the clip Conair Hair Clips for Roller Set
Cast on 20 stitches.
Knit every row until knitting measures approximately 2 inches.
On the next row, knit two together to the end of the row. You should have 10 stitches on your needles.
Knit 3 rows.
Knit the front and back loop of every stitch, increasing 10 stitches. You should have 20 stitches again.
Knit every row until your knitting measures two inches from the increase row so the sides match.
Bind off.
On the back of the bow, pick up and knit 4 stitches across the center of the narrowest point on the bow.
Knit every row until your knitting measures 2.5 inches when stretched.
Bind off leaving a long tail of yarn, and using your yarn needle and the tail, sew down the bound edge near where you picked up stitches. Weave in any ends.
Thread your sewing needle, and tie a knot around the bottom half of a hair clip so the yarn is secured to the clip.
Line up your bow on your clip. I try to put the center bars of the clip behind the knot of the bow so that the ends of the bow can move more freely.
Sew a few stitches around the front bar (1) and through the bow. Try to make your stitches as small as possible on the right side of the clip. Be sure the make all stitches in the same place. Discreetly sew along the bow to the center set of bars (2). You aren’t trying to attach anything here. You’re just moving your thread from the front to the middle without a long float in the back. It shouldn’t be noticeable Sew a few stitches around one of the center bars (2) like you did for the front bar. Move to second bar (2) by carrying the thread across the back or by sewing your way over like the previous step. Make a few stitches around the bar like you did for the others. Discreetly sew along the bow to the back of the slits (3). There are no bars to sew around here so sew around the inside of the slit near the base of the clip (3).
Tie a secure knot and weave your thread into the knitting a little bit before cutting. Use a small crochet hook to weave in the other thread end and you’re done!