https://www.cutoutandkeep.net/projects/making-simple-wire-loops-to-create-a-cute-bracelet • Posted by Groovy Mama
It is really easy to make simple, beautiful jewelry. In this tutorial I will show you some of the basic wire techniques you need to get started in jewelry making. You can make a bracelet or a necklace with this technique!
It is really easy to make simple, beautiful jewelry. In this tutorial I will show you some of the basic wire techniques you need to get started in jewelry making. You can make a bracelet or a necklace with this technique!
1) Grab a good size of scrap wire, if you have a headpin, you can go ahead and add the bead and work on closing the one side, if you have wire, cut about an 1 1/2 inches of wire.
2) Using your needle nose pliers, grab the wire about 1/4 of an inch from the edge and bend to a 90 degree angle.
It should look like this.
3) Grab the end of the wire with your round nose pliers and turn to create a loop. Here's a tip: make sure you use the tip of the pliers if you want a small loop. You can move down the pliers to create a bigger loop. I have done it before on a few pieces and it gave the piece some personality!
It should look like this.
4) Next, add the bead and, using the bead for leverage, bend the wire at a 90 degree angle again and loop it as you did before.
Tip: No matter what you are using, it is likely that you will need to trim down the other side to make the loops the same size. Just use your flush wire cutters to snip it down to about 1/4 inch, but be careful, if you cut to much and its too short, you will have to chunk that one and start over on that particular link.
5) Finishing up: When you have finished the first link, it should look like this. Here is a tip, if the loops are not lined up, grab your needle nose and round nose pliers, grab both ends and twist until they are lined up. I have to remember to do this all the time, or the piece doesn't lay right.
To create a bracelet or necklace, open the links by using your needle nose pliers to grab the end of the loop near the bead and pull towards you. Don't try to undo the loops, it won't work and it just makes it look horrible.
6) add another link and close up the link the same way you opened it. Keep adding links and it will start to look like this.
7) Once you have it long enough to cover your wrist or neck, whatever the case, add a clasp to the end of the links, same way you did with all the other links and your done. a Beautiful piece of jewelry and you made it yourself! Happy Jewelry Peeps!!!