Lego Man Cuff!!!

A Cute Cuff with a lego guy :D

Posted by picnic for Tea

About

if you dont have old lego from when you were a kid, try ebay or something :D:D

Share

You Will Need (5 things)

  • Glue Gun
  • Lego men and sheets
  • Sauce Pan with boiling water
  • Tongs
  • Bowl(s) of cold water

Steps (7 steps, 40 minutes)

  1. 1

    make sure that your sheet of lego will roll around your wrist as a cuff, and the plastic shrinks when you heat it so check first! mine was a shee so i had to cut it up, i snapped it then cut it so it had rounded edges etc.

  2. 2

    i used a nail file, but sand it back a bit so that it's smooth.

  3. 3

    dont worry if where youve sanded/cut it is white, when you boil it this will go away. (bad pic but ...)

  4. 4

    boil the water and put in the lego sheet. it takes a while for it to soften up, just watch it and check it so that it doesnt melt, it took around 3 minutes for mine, but i had a bit of trouble.

  5. 5

    once you have bent it into the right shape for your wrist, put it in the cold water.

  6. 6

    get your lego man ready with his bits and pieces, mines a robin hood/merry men one :D
    glue gun him all together so you dont lose any pieces when youre wearing your cuff. i filled his torso with glue too.

  7. 7

    sadly, you cant interchange pieces onto your cuff, as the plastic shrinks in the hot water. so you have to glue your little guy right on there. i make mine lie down a bit, just to keep him from hooking onto stuff :D so there you go :D enjoy!