Jewelry Handmade Rings Out Of Red String And Gold Beads

Jewelry Handmade Rings out of Red String and Gold Beads

Posted by

About

Glittering gold jewelry has been in style for centuries. Hence, this post will teach you to make jewelry handmade rings out of strand of red string and a gold bead. Super easy and functional!

Share

You Will Need (3 things)

  • Nylon Thread
  • Bead(s)
  • Lighter

Steps (7 steps, 120 minutes)

  1. 1

    Materials needed for handmade rings:

    1mm Red Nylon Thread

    Gold Bead

    Lighter

    Scissors

  2. 2

    Step 1: cut a 40cm long thread and fold in half. Feed the end into the hole of the gold bead. Mark the area covered by the bead.

  3. 3

    Step 2: start to tie the Snake Knot from the marked position.

  4. 4

    Step 3: make sure that the length of the knotted cord plus the width of bead equals to the circumference of your finger.

  5. 5

    Step 4: slide the gold bead onto one end. Pass the same end through the beginning loop and then back through the gold bead.

    Pull the end until the bead slides onto the loop.

    Secure the two ends by fastening a firm knot.

  6. 6

    Finally, trim off the remaining cord ends and melt the cuts using lighter.

  7. 7

    Here it is!

    This unique jewelry handmade ring pattern is actually a perfect way to express your creativity and demonstrate one’s personality. Besides wearing on your own, the ring also makes pretty good gift for both girlfriends and family.