Jackalope Ring

Make a Jackalope ring with antlers and crystal teeth!

Posted by Cat Morley

About

Share

You Will Need (8 things)

  • Ring Base
  • Crystal Clay
  • Sharpie
  • 2 Metal Antler charms from Blueberry Cove
  • Awl
  • 2 Large Crystal rocks
  • 2 Small round Rhinestones
  • 2 Small teardrop Rhinestones

Steps (13 steps, 35 minutes)

  1. 1

    Mix together the two parts of crystal clay and roll a small amount into a ball. Press into the ring base and shape the ball into an oval shape, rounded at the top but tapering down into a rounded point at the bottom. Similar to the head of a rabbit.

  2. 2

    Press the two metal antler charms into either side of the head, making sure they're attached securely and then moulding the clay neatly around the bases.

  3. 3

    Use the end of a sharpie to press two dents into either side of the rabbits head for eyes.

  4. 4

    Press the edge of the pen along the bottom half of the face where the rabbit's mouth would be.

  5. 5

    Use an awl to press lines for teeth into the bottom of the rabbit's mouth.

  6. 6

    Use the awl to shape a nose.

  7. 7

    Use the awl to pierce a dotted line down the middle of the skull to the nose.

  8. 8

    Pierce another line across the top of the skull.

  9. 9

    Press two small rhinestones into the eyes.

  10. 10

    Press two small teardrop rhinestones onto the nose and two crystal rocks into the mouth for teeth.

  11. 11

    Finally use the awl to press some line for whiskers into the cheeks.

  12. 12

    Leave the clay to cure overnight.

  13. 13

    Your new ring is ready to wear!