https://www.cutoutandkeep.net/projects/handmade-earrings-designs-make-a-pair-of-earrings-with-tree-figure • Posted by
This handmade earrings design is a cinch to make. While practicing this pair of jewelry making earrings, you will need only a few inches of aluminum wire, two beads and less than 10 minutes!
This handmade earrings design is a cinch to make. While practicing this pair of jewelry making earrings, you will need only a few inches of aluminum wire, two beads and less than 10 minutes!
Supplies needed for jewelry making earrings: 1mm Aluminum Wire Round Rhinestone Bead Jumpring Earring Hook Side Cutting Plier Round Nose Plier
Step 1: Hold your wire and slide one rhinestone bead on the end. Rotate the wire around the bead to create a half circle. Make sure that the bead is secure and will not fall down.
Step 2: Create the zigzag pattern using a pair of round nose pliers. Each consecutive zigzag should decrease in size.
Step 3: Keep a length of 1cm long at end of the wire and cut off the excess. You can also adjust the space between each layer if you feel that your design is not straight enough.
Step 4: Make a loop with 1cm leftover wire.
Step 5: Hook on the ear wire through the loop you just made.
Step 6: Repeat steps 1-5 to complete the pair! You’ve finished making your handmade earrings design. Did you notice how easy and fast it was to make this project? Once you know how to make these jewelry making earrings, you can wear them, gift them or sell them!