Halloween Candy Corn Earrings
Make some clay candy corn earrings for Halloween.
Posted by The Polymer Clay Cookbook
About
Every year, the first appearance of candy corn in the grocery store signals the true beginning of fall, which means it’s time to start seriously planning our Halloween costumes. My personal favorite from childhood was the year I was a superhero, complete with shiny handmade cape and nifty boots. Of course, I kept having to tell people that, no, I was not Superman; I was Super Jessie. For this project we’ll create a piece of candy corn a bit smaller than the real kind.
Yield: 1 piece
Share
You Will Need (9 things)
- Needle Tool
- 2 Earring Posts with 4mm fl at pads
- 3/16" (4.7 mm) ball orange Polymer Clay
- ¼" (6.4 mm) cadmium yellow Polymer Clay
- 1/8" (3.2 mm) ball white Polymer Clay
- Cyanoacrylate Glue
- Sandpaper (220 grit)
- Cotton Bud
- Rubbing Alcohol
Steps (11 steps, 50 minutes)
-
1
Start with nice warm clay. Not sticky or mushy, but warm, so the three layers of color will bind together. Start by stacking very smooth balls of the white, orange, and yellow clays, making a snowman shape.
-
2
Holding the stack as shown, gently press it halfway flat.
-
3
You don’t want it completely squished, just gently flattened.
-
4
Rotate the flattened corn 90 degrees in your fingers. It should look a little bit more like candy corn
now—the rounded edges of your spheres of clay should be flattened a bit and starting to merge into
the next layer of color. -
5
Flatten the corn again, just as you did before.
-
6
Turn it another 90 degrees. Your corn should look even smoother and the layers more fused together.
-
7
Keep repeating the flattening and turning until your corn is completely smooth and the layers are nicely bound together. The edges should be slightly rounded. Don’t worry if the layers aren’t completely straight and even—real candy corn isn’t perfectly straight and even either!
-
8
Decide which side of your candy corn is your favorite, and place it facedown on your baking tile.
This side will be the front of your earrings. If you have fingerprints on the surface, don’t worry—they
will be mostly eliminated when you press the flat pad of your ear post into the back of the corn to
create an indentation -
9
Remove the ear post, then use a needle tool to create a rough surface inside the indentation. This
creates more surface area for the glue to bond, making for stronger earrings. -
10
Bake for 15 minutes at 275° F (135° C).
-
11
To Make Candy Corn Stud Earrings
1. Make two matching candy corns.2. Rub the front of each earring post pad over sandpaper to rough it up.
3. Rub the indentation in the back of each candy corn and the pad of each ear post with a cotton swab dipped in rubbing alcohol to remove any residual surface oils and metal flecks.
4. Add a drop of cyanoacrylate glue to the front of each ear post pad, then press the pad into the
indentation in the candy corn. Wipe off any extra glue using a toothpick (not your fingers!). Let set
overnight, or for at least 6 hours.5. If you’d like to glaze the candy corn, glaze them after they have been glued onto the posts.