Cut Out + Keep

Garden Guardian Angel Ornament

Make a garden angel ornament using a clear plastic bottle and an angel ornament

https://www.cutoutandkeep.net/projects/garden-guardian-angel-ornament • Posted by KMOM14

Make a garden angel ornament using a clear plastic bottle and an angel ornament. The inspiration for this project was the little plastic angel that did not make it back in the box when the Christmas items were put up and has been sitting on my desk for 6 months, but I have also seen ones at the dollar store that would work as well.

You will need

Project Budget
Cheap

Time

1 h 00

Difficulty

Nice & Simple
Medium screenhunter 15 2bjul. 2b14 2b07.48

Description

Make a garden angel ornament using a clear plastic bottle and an angel ornament. The inspiration for this project was the little plastic angel that did not make it back in the box when the Christmas items were put up and has been sitting on my desk for 6 months, but I have also seen ones at the dollar store that would work as well.

Instructions

  1. Small screenhunter 05 2bjul. 2b14 2b07.45

    The bottle you use depends on the size of angel that you have as it needs to be able to fit in the bottom. Remove the labels from the clear plastic bottle.

  2. Small screenhunter 01 2bjul. 2b14 2b07.44

    Paint top of the lid of the bottle with the gold paint. When dry spray with the clear acrylic sealant.

  3. Small screenhunter 02 2bjul. 2b14 2b07.45

    Paint a cross on the cardboard using a brush, allow it to dry then cut it out.

  4. Small screenhunter 03 2bjul. 2b14 2b07.45

    Flip it over and paint the other side.

  5. Small screenhunter 04 2bjul. 2b14 2b07.45

    For this side, which is the side I used facing out, I textured the paint by dabbing it with the sponge brush and squishing it down.

  6. Small screenhunter 06 2bjul. 2b14 2b07.45

    Use a box cutter (I tried using a regular knife and it was not sturdy enough and scratch the front) to start a cut along about an inch from the bottom, then use the craft scissors to cut the shape of a door.

  7. Small screenhunter 07 2bjul. 2b14 2b07.46

    This is what it will look like when you are done.

  8. Small screenhunter 08 2bjul. 2b14 2b07.46

    Put the cross in the bottle (you may have to trim it to fit).

  9. Small screenhunter 09 2bjul. 2b14 2b07.46

    Apply the clear glue to the edges to hold the cross in place.

  10. Small screenhunter 10 2bjul. 2b14 2b07.46

    Squeeze the caulk into the bottom of the bottle and distribute it evenly using the end of the sponge brush.

  11. Small screenhunter 11 2bjul. 2b14 2b07.47

    I put a decorative stone on the back of each edge of the bottle.

  12. Small screenhunter 12 2bjul. 2b14 2b07.47

    Put the angel in the bottle and press it down slightly into the caulk.

  13. Small screenhunter 13 2bjul. 2b14 2b07.47

    Use a push pin to make a hole in the door and a hole just to the right of the door.

  14. Small screenhunter 14 2bjul. 2b14 2b07.47

    Put the large jump ring through the hole and bend to close and you are done. I put mine out on a piece of marble and put 4 decorative stones in the front, but you could put it wherever you like.