Electric Bracelet

About

You Will Need (3 things)

Steps (9 steps, 40 minutes)

1. 1

   Gather materials. Cut a piece of tape about 12" long, it should be twice the size of your bracelet. Fold/stick tape in half. Begin studding by pushing the stud through the tape (double layer of tape works best) and fastening the prongs.

2. 2

   Here is a look at the back.

3. 3

   Continue studding...

4. 4

   Now that you're done, notice the prongs on the back. Here at NYDS we believe in safety first so we're gonna cover these up with a piece of tape. Cut a piece that will cover that section of the bracelet and stick it on.

5. 5

   Here ya go!

6. 6

   Now take our your velcro. Cut half of one dot to use on this bracelet. That's all you need!

7. 7

   Stick the half piece of velcro onto the end of your bracelet. MAKE SURE THE BRACELET WILL FIT FIRST! You can always add tape if it's too small, or cut off extra tape.

8. 8

   Stick it together as shown.

9. 9

   Haute!! Electric!! To DIY for...and cheap too!