Diy Wire Wishbone Pattern Earrings

DIY Wire Wishbone Pattern Earrings

Posted by

About

With aluminum wire and stone beads you can make cheap personalized jewelry in a quick and easy way! This tutorial is going to show you how to make DIY wire earrings in a wishbone pattern.

Share

You Will Need (3 things)

  • Wire
  • Glass
  • Round Nose Pliers

Steps (4 steps, 120 minutes)

  1. 1

    Materials and tools:

    1.5mm bisque aluminum wire

    0.5mm bisque copper wire

    Cubic millefiori glass

    Round nose pliers

    Flat nose pliers

    Wire cutters

  2. 2

    Step 1: Make earring dangles

    1st, cut two pieces of aluminum wire that measure about 10cm;

    2nd, slightly bend it in half with round nose plier;

    3rd, cut a piece of 15cm copper wire and coil it around left side of one beaded aluminum wire ;

    4th, coil 5 times, stop to add a cubic bead on and then coil around the right side;

    5th, do another 5 times and cut off excess copper wire;

    6th, repeat above process to make the other dangle.

  3. 3

    Step 2: Attach ear hooks to the dangles

    1st, with aluminum wire and pliers make a pair of ear hooks;

    2nd, open the loop of the ear hooks and attach dangles to them;

    3rd, flatten the ends of earrings.

  4. 4

    The final look is like below:

    Now the DIY wire earrings tutorial is finished! So are you satisfied with the wishbone earrings? With sufficient supplies, you can create more cheap personalized jewelry pieces. Prepare a stack of earrings, and give a go to this summer jewelry binge.