Diy Screen Printing

DIY screen printing (from threadbangers)

Posted by Scarlet-Begonias

About

I got this from a ThreadBangers tutorial.

You may see the time for this project and think, "HOLY MOLARS!" But a lot of it is wait time and drying time. Active time is about an hour depending on how detailed your image is.

Share

You Will Need (10 things)

  • Fabric Paint
  • Embroidery Hoop
  • 1 Paint Brush
  • Mesh Fabric
  • Clothes / Garment To Print On
  • Mod Podge
  • Cardboard
  • Iron
  • 1
  • 1

Steps (6 steps, 420 minutes)

  1. 1

    Gather materials. For material, I used a kids beach sarong I found at a thrift store ($1.99) Print the image you would like to use and size it to fit your hoop. (I used irfanview)

  2. 2

    Set the fabric on the inner hoop and tape your image to the back. Trace the image onto your fabric, I, however, didn't, Can't remember why.. xD

  3. 3

    Paint with the Mod Podge in the negative space. This takes forever to dry, you can use a hair dryer to help speed it up. It's ok if it looks a little wonky, you can touch up with your fabric paint after you've printed.

  4. 4

    Place the screen where you would like to print on your garment, I used a onesie. Place a piece of cardboard inside the onesie to prevent bleeding. I used cardboard from a 12 pack of soda. Then using another small piece of cardboard pull the paint over the design. Remove the screen and do whatever touch ups you need.

  5. 5

    Wait for the paint to dry according to the instructions on the bottle, this cannot be sped up.

  6. 6

    Cover your design with a piece of paper from a grocery bag and iron on medium for 3-5 mins to heat set the image. and you're done!! Wash according to the instructions on the fabric paint bottle, (mine says wash garment inside out after 72 hours of applying the fabric paint)