Diy Patched School Bag

This took a lot longer and was much harder work than I anticpated when I started.

Firstly I had to create stencils for each of the fifteen patches, by tracing images from my computer screen onto paper, then cutting them out using a craft knife, (which is fiddly if your patches are quite small, and even worse if you have small lettering, as I found out).

Then I painted the patches, using double sided sticky tape to keep the stencils in place and a sponge instead of a brush, to make the edges sharper (brushes can often slip under the stencil slightly without you noticing, leading to wobbley edges). And after leaving them to dry, I ironed them to set the paint and make it waterproof.

Then came the pinning and stitching; also the point where I realised just how thick the fabric of the bag was, at the expense of pushing the needle only to have the blunt end go backwards into my finger rather than go through the bag (thimbles are a life saver). But after several hours of stitching (I chose a deliberately messy stitch so I didn't have to worry about being neat, plus I think it complimets the bag quite well) I was done.