https://www.cutoutandkeep.net/projects/diy-cute-kitty-beret • Posted by carlyjcais
Inspired by the kitty hats I've been seeing in the latest issues of Vivi Magazine, I decided to make my own! And it couldn't be easier than building off what you might already have - in my case, an old pirate hat!
Inspired by the kitty hats I've been seeing in the latest issues of Vivi Magazine, I decided to make my own! And it couldn't be easier than building off what you might already have - in my case, an old pirate hat!
You Need these materials
Use the craft knife to cut around the crown of the hat.
Separate the crown from the brim.
Use scissors to refine the edge and smooth it.
Now, you can build your kitty ears on the crown of the pirate hat as-is, but I wanted a more finished, rounded-edge beret look to my hat. The next steps are optional. You can skip to Step 14 if you like your hat the way it is. Cut a piece of felt large enough to cover the hat completely.
Cover your hat with felt glue. Do not put glue on the sides of the hat yet, just the top.
Press the felt on firmly to bond. It helps to do this over a curved surface, like your knee. Use clothespins to pin the edges to the hat edges, tucking the extra felt to the inside.
Heat some water to boiling in a teakettle. Wearing gloves to protect your hands, place the hat edges in the steam for a few seconds, and pull away. This will heat and soften the felt, and make it pliable.
Firmly press and pull the felt over the edges of your hat to mold the new layer onto it.
Allow to cool and dry with the clothespins still on the edges.
Once dry, tuck the excess felt under itself at the outer sides. This will create the "poof" of the beret-shape. (You may have to hit it again with the steam to smooth out excess felt and prevent a lot of wrinkling and folding.)
Now spread glue at the edges to secure the tucks.
Pin again to secure the edges until the glue dries.
Cut two triangles out of felt for your ears.
Use the cutter to slice a small V on the top of the hat, to one side.
Closeup of the V; the tip points to the back of the hat.
Push a triangle of felt into the cut from the inside of the hat.
Pull the tip through to the outside.
Pull it through to your desired height.
Trim the felt on the inside of the hat, and add some glue to it.
Tape the excess felt onto the glue until it dries.
You're done! I hope you enjoy your new Cute Kitty Hat!