Digital Coral Necklace
I love how the dangly parts move with you, and they look just like real coral!
Posted by Brittany Forks
About
This necklace was inspired by The Little Mermaid - one of my favorite movies. I love how the dangly parts move with you, and they look just like real coral!
Customizing your app:
- Making the herringbone chains out of more tan resistors (instead of blue) for a more neutral look.
- Add a herringbone cluster every 1 1/2 inches (3.8 cm) throughout the necklace.
- Attach only one herringbone cluster at the center, but make it super long.
Share
You Will Need (7 things)
- 20 - 25 small blue Resistors
- 5 medium tan Resistors
- 25 small tan Resistors
- 1 Toggle Clasp
- Needle Nose Pliers
- Round Nose Pliers
- Wire Cutters
Steps (6 steps, 60 minutes)
-
1
Take all the tan resistors and trim all the leads to about 54 inch (1.3 cm). Then loop the ends with your round-nose pliers.
-
2
Chain all the tan resistors together. randomly spacing the medium ones throughout. Stop when the chain is 18 inches (45.5 cm) long.
-
3
Fasten the toggle clasp components at each end of the chain.
-
4
Take the blue resistors and cut one lead completely off each one, then trim the remaining lead to about 16 inch (1.3 cm), Loop all the ends with round-nose pliers.
-
5
Make three "herringbone" chains with the blue resistors, following the pattern in the illustration. Be sure your loops are small enough that the resistors don't slight right through. I've suggested using 20 to 25 small blue resistors to divide into three herringbone chains; the final count is up to you.
-
6
Attach the longest herringbone blue chain at the exact center of your tan resistor chain. Position and attach the other two blue chains about 136 inches (3.8 cm) apart on either side of the center.