Devil Horn Fascinator

As worn by the Devil's girlfriend.

Posted by Cat Morley

About

Share

You Will Need (13 things)

  • Red Hat Base with comb on the bottom
  • ½ m Red Feather Boa
  • Polymer Clay
  • Black Millinery Netting
  • Red Glitter
  • Red Gem(s)
  • Paper Glue
  • Spray Adhesive / Varnish
  • Ribbon
  • Hole Punch
  • Needle
  • Thread
  • Scissors

Steps (17 steps, 90 minutes)

  1. 1

    Start off with two equal lumps of clay.

  2. 2

    Mould the clay in to horn shapes. Don't worry too much about bumps and imperfections, as we'll cover them in a minute, just make sure to get the desired shape.

  3. 3

    Make two holes in the base of the horn, one at the front and one at the back.

  4. 4

    Repeat for both horns.

  5. 5

    Lay down a paper towel, or something to protect your work surface and place the horn on top. Take some paper glue and dribble it over the horns, making sure to cover the horn completely.

  6. 6

    Stand the horns up in a tray, or something to catch the glitter, and sprinkle with glitter until the horns are completely covered. You may need to do a few coats.

  7. 7

    When you are finished, spray the horns with adhesive or gloss to secure the glitter in place.

  8. 8

    To make the fascinator, you will need a hat base with a comb on the bottom. You can make these yourself, or pick one up in a craft shop.

  9. 9

    Punch holes through the front and back, at either side of the hat base, so that you have four holes. These should be about an inch in from the edge.

  10. 10

    Cut four short lengths of red ribbon and tie each through the holes in the hat base and then through the holes of the horns. Knot well to secure in place.

  11. 11

    The horns should sit nicely at either side of the hat base. Cut off any excess ribbon.

  12. 12

    Next, take the feather boa and place the one end in the middle of the hat base, pull it through the front of the horns.

  13. 13

    Wrap it around each horn, bringing it back in to the center and stitch in place. It should cover the hat base entirely, so that none of it is visible.

  14. 14

    Take a small rectangle of millinery netting and twist in the middle, to create a bow.

  15. 15

    Place in between the two horns, in the middle of the hat base and stitch in place.

  16. 16

    Embellish by glueing a red gem on to the front center of the fascinator.

  17. 17

    Wear with pride and a devilish smile.