Crochet Button Bookmark

About

You Will Need (3 things)

Steps (10 steps, 10 minutes)

1. 1

   Gather up your buttons, then decide on an order. The one on the far right will be alone, so it's a bit bigger.

2. 2

   Thread your needle and start adding your buttons to the thread. In crochet, if you are going to include beads, or buttons in our case, you have to thread them on your string before you start crocheting. For buttons with holes (as opposed to the buttons with shanks), thread through the first hole from the back to front, then front to back through the next.
   
   
   Continue until all are threaded.

3. 3

   The last button you thread is the first we work with. Mine is a shank button, so I wrap the thread around a few times to secure it. Knot the loose thread end.

4. 4

   Push all the buttons down the thread toward the ball.
   
   
   Now we get to start crocheting. Forget about the thread end for now (we’ll weave it in later) and pick up the other end that leads to your buttons and grab your hook. Don’t be afraid!
   
   
   Shove the hook under 1, 2, or all the wraps behind the first button.

5. 5

   With your hook under all the wraps, grab the working thread and bring it through. Now, you should have a loop on your hook! You’re ready for your first chain stitch. The chain is the foundation to crochet. You basically wrap the thread around your hook and pull a loop through the loop already on your hook. You do so for however many chains you need.
   
   
   Make about 5 or 6 chains, then slide the next button down next to your hook.

6. 6

   With the second button snug up against your hook, facing down, just make another chain right over it. Forget it’s there, even! With the buttons already threaded on your string, you don’t NEED to do any more.

7. 7

   Make some more chains until it’s time for your next button. The number of chains you make depends on how big your buttons are. I like to leave a little wiggle room, so with bigger buttons, I sometimes make up to 10 chains. Just eyeball it.
   
   
   Scoot the next button up to your hook and chain it in. This one had a shank–a big one!– so I stuck my hook through it and grabbed another loop to chain it in even more. I did this a few times just because. It isn’t really necessary, but it’s an idea, if you feel your shanky buttons are too loose.

8. 8

   Make some more chains, scoot the next button up, and chain it in. This was my second to last button on my thread.
   
   
   Now, all but one button have been crocheted together. If you’re using more than 5 buttons, keep going! Add all the buttons you want on this end. It’s time to make the part of the bookmark that will actually be IN your books. I made a chain of about 125 stitches. That sounds like a lot, but it’s only about as tall as your average book. I didn’t want any buttons INSIDE my books, of course, because that would defeat the purpose of a pretty bookmark on your shelf.

9. 9

   125-ish chain stitches later, you’re ready to attach your final button (if you’re adding more than one button to this end, crochet them in the way we did on the other side). Bring in real close and chain it! You could make an extra chain, cut your thread and call it a day, or do what I did and secure that baby in a little more.
   
   
   To do so, I pushed my hook through one of the holes in my button and grabbed the yarn OVER the button from the front to the back, then I grab the thread over the button again and make a chain stitch. After that, I slip stitch into my chain by pushing my hook through one of the stitches and pulling a loop of yarn through the chain and the loop on your hook. Make one final chain to fasten off.

10. 10

    Use your needle to weave in the ends and you are DONE!