https://www.cutoutandkeep.net/projects/citrine-zig-zag-bracelet • Posted by MillLaneStudio
Creating the pretty zig zag pattern in this bracelet is a simple process using simple loops to connect the beaded head pins together.
Creating the pretty zig zag pattern in this bracelet is a simple process using simple loops to connect the beaded head pins together.
Place the loop of the eye pin against the 3/4" (2cm) mark on the ruler.
Hold the eye pin in position with your thumb and cut it flush with the end of the ruler. Cut the head pins to the same length using the same method.
String a bell flower and a bead cap on the eye pin. Grip the eye pin 3/8" (1cm) from the end with the flat nose pliers.
Bend it at a 90° angle.
Turn a simple loop.
String a bell flower and a bead cap on a head pin and insert it through the loop you just formed. Bend the head pin at a 90° angle (3/8" (1cm) from the end) and turn a simple loop.
Repeat Step 6 until the bracelet is approximately 6 1/2" (165mm) long.
Check the length of the bracelet against your wrist. Take into account the length of the toggle clasp and add as many components as necessary to fit your wrist.
Open a jump ring and hook on two closed jump rings. Close the jump ring.
Open a fourth jump ring, hook on the chain of 3 jump rings and the loop of the last component you added to the bracelet.
Open the first jump ring of the chain and attach the bar of the toggle clasp.
Attach the ring of the toggle clasp to the other end of the bracelet with a jump ring.