Christmas Card Ball Decoration

Easy decoration my mom taught me

Posted by quirky been v.

About

Some parts are tricky, but other than that its easy and looks cool. ps, you'll know what i mean when you get there, but in step 5, my circle was 3 1/4 inches across, so the triangle length was 3 inches. you can just use that for a measurement instead of using a can and goin through all that trouble measuring.

Share

You Will Need (5 things)

  • Scissors
  • Can
  • Glue
  • 20 Christmas Cards
  • Ruler

Steps (17 steps, 60 minutes)

  1. 1

    Gather up your cards, glue, scissors and a can. The can is used as a template to make circles. The bigger the can, the bigger the circles, the bigger the ball.

  2. 2

    Take a card, and place the can over a decorative area, and trace around it. Repeat to all other cards.

  3. 3

    Once your done with the last step, cut out all of the circles. (sorry yo can see the line, it was really faint)

  4. 4

    Lay all of your circles off to the side. We'll get them in a minute. (Sorry, un-neccasary step)

  5. 5

    Ok, this is the hard step. Use your can to make another circle, this time on a regular piece of paper or tagboard and then cut out. Tagboard would be better. Take your ruler, and make an equilateral triangle,(all sides the same length, to you un-math geeks)that fits inside the circle, touching the edges. Sorry if thats confusing. See picture for example. Then cut out the triangle you've just made.

  6. 6

    Like I said, cut out the triangle. (another unnecassary step) I took too many pictures, so...

  7. 7

    Lay the triangle onto a circle of Christmas card, and trace. Make sure the corners of the triangle line up and don't go outside the edges of the circle.

  8. 8

    Then fold on the lines you just traced. If you pressed the pencil hard enough, it should fold really easy. Repeat with all other circles.

  9. 9

    Set out 5 circles. Ok, take 2, and put a little glue on a flap, on both. The 2 white areas in the pictures. Glue them together, and hold until they stick good.

  10. 10

    There, glued together.

  11. 11

    Glue all 5 together, like this. Just keep adding another to an open flap, until you reach 5, then glue together. See picture.

  12. 12

    Repeat, and make another. You should have 10 circles left.

  13. 13

    This part is really confusing. Ok, by now you should have 2 half-circle things that look like hats. Take an open flap on the bottom, and glue another circle onto it. (The Santa holding the lamp) Then, go to the next open flap, and glue another circle on.(The stocking one) Then there should be 2 open flaps on the Lamp Santa and the Stocking circles. Shove another circle into the middle and glue. (The red poinsetta one) Repeat this all around.

  14. 14

    This is a bad pic; I'm sorry. Ok, take the 2nd "hat" you made earlier. The "bowl you just made in the last step should have flaps open around the bottom. Flip the "bowl upside down, so the flaps are sticking up. Take the "hat" and put glue on all of the flaps. Glue the hat and the bowl together.

  15. 15

    There, thats a better picture of the last step.

  16. 16

    ALL DONE! Just somehow thread a ribbon through one of the circles and...

  17. 17

    hang from somewhere with a thumbtack! It looks really complicated, but it's really not... enjoy!