Charming Corsage Necklace

An elegant jewellery set in the style of a delicate corsage.

Posted by Beads Unlimited

About

Twisting silver plated wire is an easy way to make clusters of beads, by adding focal points of pink ceramic beads you can create an elegant jewellery set in the style of a delicate corsage.

As the green glass beads are a mixed packet, your necklace will not be exactly the same as pictured, so play around to make your own clusters.

Share

You Will Need (18 things)

  • high quality Glass Beads mix green
  • Ceramic Beads glazed round shocking pink
  • Bead(s)
  • Bead(s)
  • 2 x packets 3mm round silver plated Bead(s)
  • Bead(s)
  • 1 x flower connector silver coloured Bead(s)
  • 1 m trace Chain silver plated
  • 1 m heavy Chain silver plated
  • 1 x memory wire Bracelet
  • 1 x memory wire Choker
  • 0.4mm Wire silver plated
  • 1 x metre 2.5mm Suede pastel pink
  • Jump Ring(s)
  • 5mm Jump Ring(s) silver plated
  • 2 x flat leather Crimp(s) silver plated
  • 36 x Headpin ssilver plated
  • Pliers

Steps (8 steps, 120 minutes)

  1. 1

    Cut a 60cm length of heavy chain. Start with the first link of the chain and weave the memory wire choker in and out of each link. Use the round nosed part of your multi pliers and bend the memory wire into a loop and catch the first link of the chain in the loop, you need to be firm with the memory wire. Repeat for the other end.

  2. 2

    20cm from the end of the loop start your wire wrapping. Cut 25cm of 0.4mm silver plated wire. Wind one end into the links of the chain weave through until secure. Thread a bead onto the wire, weave the wire through the chain link and pull tight. Add beads in this way until the beaded section is 10cm long. Make another cluster close to the end large enough for one pink ceramic bead.

  3. 3

    Onto a headpin thread a 3mm silver spacer bead. Using the cutting part of your multi pliers trim the headpin 1cm above the bead. Use the round nosed part of the pliers bend into a loop and close. Make 6 more.

  4. 4

    Cut 10cm of 0.4mm wire. Thread through the pink ceramic bead, through the seven beaded headpins back through the centre of the bead and pull tight. Attach to the centre of the small cluster of green beads by winding the ends of the wire through the chain until securely attached. Make three more and add them in the same way to the large cluster.

  5. 5

    Cut two 22cm lengths of trace chain and cut a 22cm length of pink suede. Attach a flat leather crimp to either end of the suede. Use the flat part of the multi pliers and squeeze the crimp flat one side at a time.

  6. 6

    Using the round nosed part of the multi pliers open a 5mm jump ring, add the chain, the suede and the flower connector, close the jump ring. Open another jump ring, attach the flower connector and join to the plain end of your necklace. Open another jump ring thread on the loose ends of chain and suede and attach to the other end of your necklace. Close the jump ring.

  7. 7

    To make the bracelet.
    Cut 30cm of heavy chain, then follow step 1 using the shorter memory wire bracelet.
    Follow step 2 to create a cluster of green beads in the centre of your bracelet and add a single central pink bead by following step 3 and 4.

  8. 8

    Your finished necklace should look like this.