Bungee Cord Bangles

This is a super easy project, entirely made with hardware store components.

Posted by Vera V.

About

This easy project from my booklet "Bungee Band Bracelets and More" requires no clasp or closure, just a simple length of cord – a quarter inch thick or more – and a set of matching hex nut caps or simple finials, which can be found in the lighting department of a hardware store. The result is a classic bangle which looks best when worn on both arms and in multiples, all the way up to your elbow if you dare. More is more!

Share

You Will Need (7 things)

  • Diamond braided polypropylene Rope
  • Two finials or hex nut caps to match the diameter of Rope
  • Scotch Tape
  • Cylindrical object around which to Wrap your bangle
  • Hot Glue Gun
  • Super Glue
  • Scissors

Steps (4 steps, 60 minutes)

  1. 1

    Cut a 31" length of cord. Wrap the cord with a piece of clear scotch tape before cutting to keep the fibers together. Gently singe both ends of the cord with a lighter to prevent fraying.

  2. 2

    Put a few drops of super glue into the finial or hex nut cap and slip over the end of the cord. Hold firmly in place for at least 30 seconds, then let dry for about 20 minutes. Do this for both ends.

  3. 3

    Wrap the cord around your cylindrical mold, securing with little dabs of hot glue between the cords as you go along. It's best to do this in small sections and hold the cords together for about 30 seconds, hot glue sets and dries pretty fast.

  4. 4

    Don't worry if your pieces ends up covered in glue threads, these can easily and safely be pulled off once your bangle is completely dry.