Braided Guitar Pick Bracelet

Feel like a rockstar!

Posted by Dori K.

About

When I wear this bracelet, I feel like a rocker chick. ;P In this tutorial, I'll guide you through the steps so you can feel like a rockstar too. This is a perfect project to use in coordination with the Pick Punch because it allows you to incorporate different designs within your pick (while recycling old materials at the same time)! Good luck making this bracelet. ;D

Share

You Will Need (7 things)

  • Cord
  • Scissors
  • Jewelry Pliers
  • Needle
  • Nail File
  • Jump Ring
  • Guitar Pick

Steps (6 steps, 20 minutes)

  1. 1

    Gather your materials, starting with the guitar pick. (In this tutorial, I'll show you how to shape the pick into a heart. These are optional steps of course and this bracelet can most definitely be made with a plain guitar pick as well.) Since my guitar pick had lettering that I didn't like on it, I used nail polish remover on a cotton ball to remove it. Use a pencil to draw a line down the center of the pick. This will help with making the heart symmetrical. Next, draw two curved lines to form the top of the heart. You can fill this area in to help you see what the pick will look like.

  2. 2

    Cut the area that you have just shaded in. It's okay if it's not perfect after you cut, but make sure that you have the desired shape down in general. Then, use a nail file to smooth the sides of the pick out. Your heart shaped guitar pick is done!

  3. 3

    Time to poke a hole in your heart! Your heart shaped guitar pick, that is. Locate an area that isn't too close to the edge of the pick, but at the same time will still allow your jump ring to go through. Take a needle or another sharp object and start to twist through the pick. You may want to do this on a piece of scrap wood or while holding the pick in the air. Keep twisting until you have a hole big enough for the jump ring.

  4. 4

    Open the jump ring with a pair of pliers and thread the jump ring through the pick.

  5. 5

    Take 3 pieces of cord that can wrap around your wrist with a few inches to spare. Tie a knot at one end, leaving adequate room. Braid the cord as you normally would for a basic braid. After you're done, tie the open end off with another knot. String your guitar pick on.

  6. 6

    You're done! This bracelet is perfect as a gift or for yourself. Now you have a guitar pick for all those emergency situations when you need one. (: