Bracelet Loop

Crafting with Paracord

Posted by Ulysses Press

About

This is how you start a paracord bracelet without using a buckle. The two strands used to tie the loop can be the same or different colors.

Share

You Will Need (1 thing)

  • Paracord

Steps (5 steps, 5 minutes)

  1. 1

    Start with the two strands placed vertically beside each other.

  2. 2

    Form a loop with the right red strand and then bring it over the two vertical core strands and under the left blue strand.

  3. 3

    Form a loop with the blue strand, bring it over and around the red strand, and then bring it underneath both core strands and out the red loop.

  4. 4

    Take the blue strand up, to make a loop, then bring it down through the blue loop on the left side, then under both core strands, under itself, and out the red loop.

  5. 5

    Pull the strands tight and adjust the size of the upper loop as needed. The opening needs to be just a bit larger than the intended size of the Bracelet Clasp that you intend to tie.