Bow Tie Ring :)

Cute ring for almost any occasion. :)

https://www.cutoutandkeep.net/projects/bow-tie-ring • Posted by Trisherr Polskie :)

I was inspired by the bow from my juicy couture perfume. I would wear it around and thought well i could make this. Yay. A new project for me.

You will need

Needle & Thread 4 in length Ribbon half inch wide 1 in Elastic Band(s) Hot Glue Gun Glue Stick A Pair Of Scissors

Project Budget

Time

Difficulty

Description

I was inspired by the bow from my juicy couture perfume. I would wear it around and thought well i could make this. Yay. A new project for me.

Instructions

1. 

   To make your bow first cut your ribbon (i think 4in. is a good length.) Then thread your needle. Once youve done that take your needle and weave it through the middle of the ribbon. In this case i used red ribbon and red thread.

2. 

   After, pulling the thread through the ribbon wrap the thread around the middle of the ribbon(where you pulled the needle through) and pull the needle through the center of your bow one time then cut your thread. :) Wallah you have your bow. :)

3. 

   Alrighty, so you have your bow made now for the ring part. Take your elastic and measure it around the finger you would wear the ring on then cut it. By this time your glue gun should be hot. Glue the ends together. Let them overlap a little bit.

4. 

   Okie Doke. Now just glue your bow onto the elastic ring. And there you have it. I always glue my bow on top of the overlapped part for neatness. :) Enjoi.