Blue And Copper Plates
Painting On Pottery
Posted by Search Press
About
Safety note: for plates intended for daily food use, you are advised to avoid decorating the eating surfaces.
Share
You Will Need (8 things)
- Three white 20cm (8in) diameter earthenware Plates
- Pébéo Porcelaine 150 Paint : Abyss black 41, Vermeil gold 45, Ivory 43
- Paint Thinner (Pébéo)
- Round Stickers , 1 and 1.5cm (approximately ½ and 5⁄8in) in diameter
- An Atomizer spray (found in many travel kits)
- 0.5cm (¼in) Wide Adhesive Tape
- A large Flat Brush , size 18
- A small Flat Brush , around 0.5cm (¼in), size 6
Steps (3 steps, 60 minutes)
-
1
Plate 1
Fill half the small spray bottle with Abyss black paint and the other half with thinner. Mix well by shaking.
Spray the plate generously with Abyss black paint. Leave to dry, then quickly dip a paintbrush in the Vermeil gold paint and, holding it above the plate, tap the brush on to the handle of a larger brush to flick flecks of Vermeil gold onto the surface. Leave to dry, then use this technique again with the Ivory paint.
Paint the rim in Vermeil gold. -
2
Plate 2
Apply the 1.5cm (5⁄8in) diameter stickers in staggered rows over half the surface of the plate, and some adhesive tape in a concentric circle just inside the rim.
Fill half the small atomizer spray with Abyss black paint and the other half with thinner.
Mix well by shaking. Spray the whole plate. Leave to dry before peeling off the stickers and the adhesive tape.
Paint in the border in Vermeil gold. -
3
Plate 3
Apply the 1cm (½in) diameter stickers around half the edge of the plate and apply adhesive tape to create an arc, dividing the plate in two.
Fill half the small atomizer spray with Abyss black paint and the other half with thinner. Mix well by shaking.
Spray over the surface with the stickers. Leave to dry before peeling off the stickers and the adhesive tape.
Paint the white part in Vermeil gold using a large size 18 brush. Leave to dry, then apply a second coat.Leave the plates to dry for 24 hours. Bake in the oven at 150 °C (300°F, gas mark 2) for 35 minutes.