https://www.cutoutandkeep.net/projects/bird-nest-ring-2 • Posted by paola.frescurites
Start with a considerable amount of wire, you'll need to roll the beginning and add 3 beads.
Then, you'll roll the whole thing several times, until your like.
After this, measure 20cm of wire, and cut.
Roll the "nest" together on one side to make it secure.
Pass the tip under some rolled wire and using a pen, mold the ring twice.
It should look like this. Then, wrap the wire again around the nest, but now, on the other side.
Then, go the side, wrap a few times, cut the rest and sand the very tips.
You can use the rest at the other side, and wrap around to make it equal.
Voilá!