Cut Out + Keep

Arm Warmers From A T Shirt

Fingerless Gloves made from recycled T-Shirt

https://www.cutoutandkeep.net/projects/arm-warmers-from-a-t-shirt • Posted by Anna the Ewok

I finally got around to cutting up an old t-shirt I bought at Goodwill. I was going to use it when I went in the Darkroom so I could get chemicals on it instead of on a good shirt. Never happened. Instead, I found Caro's T-Sexy shirt (http://www.cutoutandkeep.net/projects/cut_tshirt). The sleeves came off, too, and I ended up cutting out the shoulder seam to lace up the shoulders, too. But then I had two t-shirt sleeves laying around and a shirt that needed some accessories. Thus were the Arm Warmers born!

You will need

Project Budget
Free

Time

0 h 20

Difficulty

Nice & Simple
Medium finished product 1238104526

Description

I finally got around to cutting up an old t-shirt I bought at Goodwill. I was going to use it when I went in the Darkroom so I could get chemicals on it instead of on a good shirt. Never happened. Instead, I found Caro's T-Sexy shirt (http://www.cutoutandkeep.net/projects/cut_tshirt). The sleeves came off, too, and I ended up cutting out the shoulder seam to lace up the shoulders, too. But then I had two t-shirt sleeves laying around and a shirt that needed some accessories. Thus were the Arm Warmers born!

Instructions

  1. Small step1 1238105516

    Lay out your sleeve with the seam on one side and the rest with the other. We aren't using the side with the seam (I'm going to try and figure out something to do with that later).

  2. Small step2 1238105527

    Cut off the hem. I don't like the way it rolls if you take away the whole thing, so I cut off half.

  3. Small step3 1238105535

    Slip the sleeve around your hand with the seam on the bottom. Make a 4 with your hand, and pin the tube together. Make sure it's snug. Steps 3 and 4 are the ones that take longest for me.

  4. Small step4 1238105544

    Repeat as many times more as needed so that the tube fits very well on your arm. If it's too loose, it's going to fall down a lot. Steps 3 and 4 are the ones that take longest for me.

  5. Small step5 1238105551

    Cut on the inside of the safety pins. If you cut on the outside, lacing them is going to be a challenge.

  6. Small step6 1238105560

    Cut small holes along the outside edges of the not-tube.

  7. Small step7 1238105569

    Lace them up!

  8. Small step8 1238105577

    Last step. Slip the tube on and figure out where your thumb wants to go. Mark it and cut a slit for your thumb. Adjust the laces to fit your arm, and viola! Arm warmer! Rinse and repeat for another.