Angel Pin

angel pin

Posted by princesse X.

About

this does not look that good because I did not have the right size of wire

Share

You Will Need (7 things)

  • brass Wire size 20
  • 1 6mm Pearl(s)
  • 10 3mm Pearl(s) optional
  • Wire Cutters
  • Pliers
  • Ruler
  • Pin Back

Steps (7 steps, 15 minutes)

  1. 1

    materials

  2. 2

    cut 5 pieces of wire 12 inch long and 1 16 inches
    slightly bend the 5 pcs of wire togather

  3. 3

    start wrapping the long piece of wire around the centre

  4. 4

    add the pin and continue wraping the wire tight,then add the pearl on the other end of wire

  5. 5

    shape the extra wire as a halo over the bead

  6. 6

    open the loose ends of the wires to shape wings,you can shape them any way you like,and adjust the length if you want

  7. 7

    open the wire below to shape skirt