Ancle Bracelet

  ✂︎

Favorite

Comment

List

       

Share

• 

  Step 1

  You will need: scissors, Wooden beads, and String in fun colors(you can find all of these things at Wal-Mart or any place that has a craft department)

• Step 2

  Cut the string in 3 pieces about 45inches long(and yes you will need at least that much)

• 

  Step 3

  When you get all of your pieces cut put them all together and make a knotted loop.

• 

  Step 4

  fold over about 3 inches to make the loop.

• 

  Step 5

  and then pull through. Its just basically like tying a knot except your leaving room for a loop.

• 

  Step 6

  Their is the final knot with loop.

• 

  Step 7

  You are know ready to start the weaving part.

• 

  Step 8

  Cut the execs string off close to the knot.

• 

  Step 9

  Take the string on the left side....

• 

  Step 10

  and put it under the other two strings( it should look like a 4)

• 

  Step 11

  Then put the strings end through the loop you just created and pull it tight all the way up to the knot

• 

  Step 12

  Do steps 9-11 until you are ready to finish it off

• 

  Step 13

  You want to take your bead and pull it through all three of the strings .....

• 

  Step 14

  and tie a knot with all the strings at ounce (just like you started it except you don't make the loop)

• Step 15

  You are finished!!!! to wear it pull the bead over the loop (in the begging)

Comments

Leave your comment