Ancle Bracelet

you can also use this tenique to make bracelets, necklaces, and even key chains

Posted by Sunny

If you have and questions just post them i will try to answer all of them.

1

You will need: scissors, Wooden beads, and String in fun colors(you can find all of these things at Wal-Mart or any place that has a craft department)
2

Cut the string in 3 pieces about 45inches long(and yes you will need at least that much)
3

When you get all of your pieces cut put them all together and make a knotted loop.
4

fold over about 3 inches to make the loop.
5

and then pull through. Its just basically like tying a knot except your leaving room for a loop.
6

Their is the final knot with loop.
7

You are know ready to start the weaving part.
8

Cut the execs string off close to the knot.
9

Take the string on the left side....
10

and put it under the other two strings( it should look like a 4)
11

Then put the strings end through the loop you just created and pull it tight all the way up to the knot
12

Do steps 9-11 until you are ready to finish it off
13

You want to take your bead and pull it through all three of the strings .....
14

and tie a knot with all the strings at ounce (just like you started it except you don't make the loop)
15

You are finished!!!! to wear it pull the bead over the loop (in the begging)