https://www.cutoutandkeep.net/projects/3d-origami-clematis • Posted by GMC Group
Real enough to hold its own even when set alongside the actual plant. The clematis comes out in a large flower, so put it with a big vase.
Real enough to hold its own even when set alongside the actual plant. The clematis comes out in a large flower, so put it with a big vase.
Octagonal Base Make the creases.
Turn over Rotate
Make the creases.
Bring together along the creases. Rotate
Open the flap out and then flatten it down.
Fold the remaining three flaps in the same way.
Cut at the position shown and then unfold.
This is how it looks on completion
CORE ● Made from the octagonal base 1. Crease in line with the middle.
2. Fold the remaining seven flaps in the same way.
3. Fold only one flap.
4. Open the flap out and then flatten it down.
5. Bring the pleats together so that they follow each other round. (see p.36)
6. Turn over
7. It will look like this.
8. Bring together along the creases, as shown in the illustration.
How it should look in mid-fold
9. Fold the edge in line with the middle.
10. Fold the top again.
11. Fold the remaining seven flaps in the same way as in steps and .
Rotate
This is how it looks on completion!
FLOWER ● Made from the octagonal base 1. Crease in line with the middle.
2. Fold the remaining seven flaps in the same way.
3. Make a crease at the centre only by folding in line with the creases that you made in step .
4. Fold the remaining seven flaps in the same way.
5. Crease in line with the creases that you made in step .
6. Fold the remaining seven flaps in the same way.
7. Fold only one flap.
8. Open the flap out and then flatten it down.
9. Bring the pleats together so that the flaps follow each other round.
Turn over
11. Bring together along the creases shown in the illustration.
How it should look in mid-fold
12. Crease along a line connecting the points marked○ and ○.
13. Fold along the crease that you made in step .12
14. Fold along the creases that you made in step .12
15. Fold the remaining seven flaps in the same way as in steps 12 to
16. Fold the middle towards you,
18. and then fold the section that sticks out at the front to the opposite side.
19. Fold the remaining seven flaps in the same way as in steps 17 and 18.
...
21. Slit at the points shown.
...
23. Turn the model out by pushing on the bottom with your fingers.
This is how it looks on completion!
Flower core Glue Flower 20 gauge wire, curled at the tip Pass a length of 20 gauge wire, curled at the tip, through the flower, and glue on the core from above.