https://www.cutoutandkeep.net/projects/crochet-necklace-or-bracelet • Posted by KMOM14
The project is made with single crochet so crochet skills are not required; just put yarn through a loop and repeat!
The project is made with single crochet so crochet skills are not required; just put yarn through a loop and repeat!
You can choose any type of yarn you would like and the size of the hook will determine how thick the single crochet will be. You start by tying a loop big enough for the crochet hook to fit through (most people use a slip knot) leaving a tail - I would recommend several inches for the tail as it was a challenge to get the button attached to that end. then pull the yarn through and repeat until
Repeat pulling yarn through the loop creating small loops until it is the length that you want. For this project I crocheted for about an hour.
At the end, bend over to make a loop large enough for the button that you are using to go through then insert the hook into the center of where the end touches and make a loop or two and tie off in a knot,
At the beginning, thread through the button. If the end is short you may need to use a wire to secure it. The button I used had two layers (or you could use two buttons) and hid the end of the wire between the two pieces and glued to secure.
Wrap the finished project around your wrist or neck to the length you wants.